hi!
I plan to use this carburettor on V6 2.8i,
but I can not find from it the documentation in any way or the description...
I can not find from what from the motor at all...
rtype 
/ 2007-08-07 19:57:19 /
and also top view:
rtype / 2007-08-07 19:58:34 /
Good carurettor is new carburettor :) This one looks Ok.
Mysza liil (EM) / 2007-08-08 10:28:40 /
It new. Therefore I wish to use this... :)
Have very much tired attempts to assemble the good carburettor from parts old... :-[
But here on this carburettor there are no data, everywhere searched, I can not find from what V-type motor it at all. It is more similar on Solex/Pierburg than on Weber.
I wish to put correct orifice plugs (Düsen) and an emulsion tube.
Now it have 180+180/180+180 Düsen and 55 LüftDüsen.
I have V6 2.8i motor...
I use intake from 2.8 carb, have no carb crankschaft, but I this it works too for
first time...
Roman
rtype / 2007-08-08 19:45:29 /
I have found whence it: CHRYSLER 160GT 180.
Whether if sense to try to reconstruct it under 2.8 V6?
Diameter of throttles 38mm. Orifice plugs I can put others....
Probably it is necessary to search new WEBER 38 DGAS :(
Roman
rtype / 2007-08-09 21:31:24 /
hi!
Has disassembled the carburettor. Basic differences from WEBER 38 DGAS has not seen. Now I think to pick up under it details. Motor V6 2.8 PRE (ex EFI)
Following details are now (see photos):
A Main Jets 180
B Air Jets 180
C Emulsion Tubes F6 (F60)
D Idle Jet 55
E 4.5 (I think, them to not replace without problems.)
F Pump Jet 55
Also Needle Valve 175
Main Venturi 33
Drossel 38
Prompt please correct parameters...
Roman
rtype / 2007-08-18 18:16:32 /